This is a project I did many years ago (1997).
I wanted to make my own speakers but didn't have much budget. Therefore I had to use the available MDF.
|
|
The form of the speaker is like this for several reasons:
- Limited by amount of material
- Volume needed for speakers
- Size of the speakers
- Front view outlines (I made some little sketches)
|
|
I had made a nice cover for this speaker but when moving it from Utrecht to Delft one of the two broke. The interior of the speaker is made in such a way that there are two separate volumes, one for the woofer and one for the center speaker and tweeter (which is closed of by its own cover).
|
|
The speakers weigh about 10-15 kilo's each and because of their form they are hard to lift. That's why I made two handles in the sides for easy lifting. The final product is better than I thought it would be. The sound produced is reasonable, especially when you take in mind that the total cost per speaker is about 20-30 Euros'.
I still use these speakers, not as the primary but as rear speakers.
|
|